6-12 Installation TP-5393 9/93
Vehicle-floor Mount
Kohler’s mobile generator set can also be installed on
an open vehicle’ s floor, or truck bed. Follow the same
guidelines as described in the compartment mount
section. Contact an authorized Kohler service dealer
with your specific application questions.
Extended-Shaft Option
Ifyourgeneratorsetisequippedwiththeextendedshaft
option, adequate space must be allowed at the
generatorendofthesetforanadapter, flexiblecoupling
and the equipment to be operated. The extended shaft
dimensions are 15/16” dia. x 1 3/4” long with a 1/4” key
way. Mounting flange conforms to SAE J609a, Flange
B. See Figure 6-13.
2
4
5
7
8
6
3
9
1
1. 1.88 (48)
2. Mounting flange to end of shaft
3. 30° typical
4. 3/8-16UNC-2B .56(14)deep4 holes on6.500 (165.10)diameter
bolt center
5. Pilot diameter: 5.749 (146.02)-5.751 (146.08)
6. 45° typical
7. Power takeoff and shaft dimensions
8. 0.2485 (6.31)-.2505 (6.36) keyway
9. Diameter 0.9365 (23.79)-.9375(23.81)
Figure 6-13. Extended Shaft Option
NOTE
Customer must provide the adapter and flexible
coupling for the extended-shaft option.
Figure 6-14 shows a Kohler mobile generator set
mounted to a hydraulic pump. The generator set
equipped with the extended-shaft option can power
external equipment to the limit of the engine’s capacity.
Contact an authorized Kohler service dealer for your
generator set’s ability to power specific equipment.
1-921
Figure 6-14. Hydraulic pump
To Next Page
Loading...
Need help?
General