STEP
15
-
Engine System Components:
At
this point in reassembly, components such
as
governor,
-
fuel pump, carburetor,
air
cleaner, oil filter, magnetos, etc. can be reinstalled on
the
engine with new gaskets or elements where applicable
-
-
refer to the appropriate Service
Section
in
this manual for installation and adjustment instructions on
this
equipment.
STEP
16
-
Blower Housing, Baffles
&
Shrouds:
-
A.
Install lower baffles (support) on
K662
models.
(Support
baffle has been installed with gear
cover on
K482
and
K532
rnodets.
)
B.
Install blower housing. Note:
On
K662
engines with wire mesh screen, install screen on
flywheel before placing
hzng in position,
On
engines with rotating air screen, install
blower housing then screen assembly.
Use spacers between flywheel and screen assembly
to provide clearance between screen and housing.
C.
Install Lower shrouds on
both
models and starter shield on
K482
and
K532
models.
To Next Page
Loading...
Need help?
General
