Kohler KD 477-2 User Manual

- 37 -
KD 477-2 Workshop Manual_cod. ED0053029370_1° ed_ rev. 00
XIII
68
69
70
71
Protective cap tting
To prevent the entrance of dust and water which could block the cylin-
der studs to the upper crankcase, insert protective caps on the studs
themselves (g. 70).
To facilitate cap mounting, oil stud roots.
Insert on crankcase, under the rocker shaft pipes, plates for the lubri-
cation of the camshaft.
Cylinder mounting
The lower end of the cylinder is chamfered for piston ring insertion
(g. 71).
The operation can be carried out easily by using a standard piston
ring compression tool (tool 00365R0770).
Piston ring tting
Fit rings onto pistons in the following order (g. 68):
1
. Chromed compression seal ring.
2. Torsional compression seal ring
(with internal notch turned upwards).
3
. Expander oil scraper ring.
Piston ring working position
Before mounting cylinders, rotate rings 120° opposite to each (g. 69)
other with the ends of the 1st compression ring in line with the gudge-
on pin axis.
ENGINE ASSEMBLY

Kohler KD 477-2 Specifications

General

Brand	Kohler
Model	KD 477-2
Category	Engine
Language	English