MAINTENANCE
TP-6901 3/16a Maintenance 25
Section 5 Maintenance
5.1 INTRODUCTION
Preventive maintenance is critical to prolonging the life
of the KG2204 and KG2204T engines and keeping
them in optimum working condition. As the engine
runs, fasteners may loosen, parts may become worn,
clearances change, and oil picks up dirt and
contaminants. The engine may eventually become
hard to start, or may exhibit other symptoms such as
decreased power output or increased fuel
consumption.
Regularly scheduled maintenance will help to prevent
or reduce the impact of these performance issues.
Keep the engine working reliably by performing all
preventive maintenance tasks described in this section.
Accidental starts can cause
severe injury or death.
Disconnect and ground spark plug
leads before servicing.
Before working on engine or equipment, disable the
engine as follows: 1) Disconnect spark plug leads.
2) Disconnect negative (–) battery cable from battery.
Before disconnecting negative (–) battery cable, make
sure all switches are OFF. If ON, a spark will occur at
the ground cable terminal which could cause an
explosion if hydrogen gas or LPG/NG fuel vapors are
present.
Handling caustic engine fluids and
chemical products can cause
severe chemical burns, nausea,
fainting, or death.
Most chemicals such as used engine oil,
antifreeze/coolant, rust proofing agent, inhibiting oil,
degreasing agent, spray paint, and adhesives are
hazardous to health. Read and follow the user
information found on the packaging. Avoid inhalation
and skin contact. Use only in well-ventilated areas and
use a protective mask when spraying. Store engine
fluids and chemical products in a locked cabinet.
Contact your local recycling center for disposal
information and locations.
To Next Page
Loading...
Need help?
General
