.
MAINTENANCE
SERVICE PROCEDURE
REPLACE STEERING, HOIST OIL TANK AND REAR BRAKE COOLING OIL TANK FILTER
ELEMENT
WARNING
The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the
temperature to go down before starting the work.
When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it.
1. Turn the cap of oil filler (F) slowly to release the internal
pressure, then remove the cap.
2.
Remove bolt (1), then remove cover (2).
3. Take out the element, then wash the inside of the case and the
removed parts.
4.
Install the new element, then install cover (2) with bolt (1).
If the filter element clogging caution lamp lights up when the
engine water temperature gauge is in the green range and the
engine is running at 1200 - 2100 rpm, replace the element
immediately.
LUBRICATION
1. Using a grease pump, pump in grease through grease fittings marked by arrows.
2.
After greasing, wipe off any old grease that was pushed out.
(1) Fan pulley (1 place)
(2) Tension pulley (2 places)
4 - 60
To Next Page
Loading...
Need help?
General
