.
ATTACHMENTS, OPTIONS
REVO TACHOGRAPH (TCO 15-7)
INSTRUMENT LIGHTING LAMP
This lamp (19) is used for light up the instrument.
NAME PLATE
This (20) indicates the type and model.
VOLTAGE INDICATION LABEL
This label (21) indicates the voltage.
RPM RECORDING STYLUS
This (22) records the momentary engine speed on the chart.
ADJUSTMENT SCREW FOR RPM WARNING LAMP
The speed at which the lamp gives a warning can be set as desired with this screw (23).
SPEED CONFIRMATION APERTURE FOR RPM WARNING LAMP INDICATION
This (24) is the speed indication aperture for setting the desired speed of revolution.
TOTAL REVOLUTION COUNTER
This meter (25) indicates the total number of revolutions (x 1000) of the engine.
METHOD OF USE
1. Open the cover.
Insert the instrument open/lock key in hole (1), turn
counterclockwise 90°, then pull open carefully.
The cover can be opened approx. 115°. Do not open it further
than that, or pull it strongly, or put anything heavy on the cover,
as these will cause failures.
2. Set the time.
Turn time setting knob (2) to set the time.
Always set the time with the time setting knob. Turn the hand
in the direction of rotation 10 minutes beyond the correct time,
then turn back to the correct time.
Check the clock operation with the movement of minute hand.
The clock is electric, so there is no need to wind it up.
3.
Fill in chart.
Before inserting new chart paper, always fill in the required items. (Operator code No., machine code No., date,
etc.)
Fill in the above items with a steel pen.
Handle the charts carefully with clean hands, and do not fold or scratch them.
6 - 19
To Next Page
Loading...
Need help?
General
