• For the standard specification machine
1)
Loosen wing bolts (5) (2 pieces), and slide covers for
cleaning (6) on
the right and left sides of the machine,
and open those covers.
2)
Insert the air nozzle, and blow dust out forward of the
machine. Steam or
water may be used instead of the
compressed air.
3)
Install covers for cleaning (6) on the right and left side
of the machine after blowing dust out.
• For the machine with high lift boom specification
(if equipped)
1)
Remove wing bolts (7), and slide covers for cleaning
(8) on the
right and left sides of the machine, and
open those covers.
2)
Insert the air nozzle, and blow dust out forward of the
machine. Steam or
water may be used instead of the
compressed air.
3)
Install covers for cleaning (8) on the right and left side
of the machine after blowing dust out.
METHOD FOR INVERTING AND REPLACING BOLT ON CUTTING EDGE
WARNING
It is dangerous if the work equipment moves by mistake when the cutting edge or end bit is being re-
placed.
Set the work equipment in a stable condition, stop the engine, then lock the work equipment (the pilot
lamp in the switch lights up).
Turn or replace the cutting edge before the wear reaches the edge of the bucket.
MAINTENANCE PROCEDURE MAINTENANCE
4-30
To Next Page
Loading...
Need help?
General
