E-20
Preparation
Turning Power ON
Note
When turning the power ON for the first time, the display language and measurement mode must be set.
For details, refer to page E-27.
[Operating Procedure]
1
Set the POWER switch to “|”.
The power will be turned ON.
Turning Power OFF
[Operating Procedure]
1
Set the POWER switch to “ ”.
The power will be turned OFF.
Auto Power Save Function
Power save mode will be activated if the MEAS. button and navigation wheel are not operated for more
than three minutes. During power save mode, the flash circuit will not be charged. To cancel power save
mode, press the MEAS. button to start measurement.
Note
• If the MEAS. button is pressed to cancel power save mode, start of measurement will be delayed by a few sec-
onds, so keep the instrument still until the lamp flashes and measurement is taken.
• The auto power save function is not available in remote mode (see page E-89).
To Next Page
Loading...
Need help?
General
