90
S
ETUP MENU
LCD monitor brightness
Monitor brightness can be adjusted in 11 levels.
Brightness can be set individually for viewfinder and
direct viewing in the recording mode. Turn the mode
switch to the appropriate position before opening the
brightness option in section 1 of the setup menu (p. 88).
Also see page 28.
Use the left/right keys of the controller to adjust bright-
ness, the monitor image changes accordingly. Press the
central button of the controller to set the level.
Auto power save
To conserve battery power, the camera will shut down if no operation is made within a certain peri-
od. The length of the auto-power-save period can be changed to 1, 3, 5, or 10 minutes. When the
camera is connected to a computer, the auto-power-save period is fixed at ten minutes. Auto power
save is set in section 1 of the setup menu (p. 88).
An image can be displayed on the monitor after it is captured. When
used with the continuous-advance or progressive-capture drive
modes (p. 46), the images in the series are played back in a six-
frame index display. Instant playback is activated section 1 of the
setup menu (p. 88). A playback period of two or ten seconds can be
selected. To cancel the playback and save the image before the end
of the playback period, press the shutter-release button partway
down.
Instant playback
Single still images can be previewed immediately after being captured without instant playback
active. Simply continue to hold the shutter-release button down after taking the picture to dis-
play the image. Release the shutter button to end the playback.
Camera Notes
Set LCD brightness
:adjust
:enter
Low High
To Next Page
Loading...
Need help?
General
