8 ERGONOMICS 61
8.2 Handlebar position
401666-11
The holes on the handlebar support are placed at a distance of
A
from the center.
Hole distance
A
3.5 mm (0.138 in)
The handlebar can be mounted in two different positions. In this way, the handlebar can be
mounted in the position that is most comfortable for the rider.
8.3 Adjusting the handlebar position x
Warning
Danger of accidents Handlebar breakage.
– If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handlebar.
308080-01
–
Remove screws
1
. Remove the handlebar clamps. Remove the handlebar and lay it to
one side.
Info
Protect the motorcycle and its attachments against damage by covering them.
Do not bend the cables and lines.
–
Remove screws
2
. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten screws
2
.
To Next Page
Loading...
Need help?
General
