7 PREPARING FOR USE 19
– Do not exceed the overall maximum permitted weight and the axle loads.
Guideline
Maximum permissible overall weight 335 kg (739 lb.)
Maximum permissible front axle load 145 kg (320 lb.)
Maximum permissible rear axle load 190 kg (419 lb.)
– Check the spoke tension. ( p. 76)
Info
The spoke tension must be checked after half an hour of operation.
– Run in the engine. ( p. 19)
7.2 Running in the engine
– During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
During the first 3 operating hours < 70 %
During the first 5 operating hours < 100 %
– Avoid fully opening the throttle!
7.3 Preparing the vehicle for difficult riding conditions
Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can lead to considerably more
rapid wear of components such as the drive train, brake system, or suspension components. For this reason, it may be neces-
sary to inspect or replace parts before the next scheduled service.
–
Seal the air filter box. x ( p. 52)
–
Secure the air filter box lid. x ( p. 52)
–
Clean the air filter and air filter box. x ( p. 51)
Info
Check the air filter approx. every 30 minutes.
– Additionally secure the rubber grip. ( p. 61)
– Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
– Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
– Riding on dry sand. ( p. 19)
– Riding on wet sand. ( p. 20)
– Riding on wet and muddy surfaces. ( p. 21)
– Riding at high temperatures and low speeds. ( p. 21)
– Riding at low temperatures or in snow. ( p. 22)
7.4 Preparations for riding on dry sand
600872-10
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the displayed value does not equal the setpoint value:
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
To Next Page
Loading...
Need help?
General
