15 COOLING SYSTEM 83
Condition
The engine is cold.
– Position the motorcycle upright.
– Place a suitable container under the water pump cover.
101746-10
(All 125/150 models)
– Remove screw 1. Take off radiator cap 2.
– Completely drain the coolant.
– Mount and tighten screw 1 with a new seal ring.
Guideline
Drain plug, water pump cover M10x1 15 Nm
(11.1 lbf ft)
101747-10
(All 250/300 models)
– Remove screw 1. Take off radiator cap 2.
– Completely drain the coolant.
– Mount and tighten screw 1 with a new seal ring.
Guideline
Drain plug, water pump cover M10x1 15 Nm
(11.1 lbf ft)
15.8 Refilling with coolant x
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
B00071-10
(All 125/150 models)
– Make sure that screw 1 is tightened.
B00072-10
(All 250/300 models)
– Make sure that screw 1 is tightened.
To Next Page
Loading...
Need help?
General
