7 PREPARING FOR USE 20
– Change the radiator cap.
B00435-01
– Mount the dust cover for the air filter.
Dust cover for air filter (59006019000)
Info
Read the KTM PowerParts installation instructions.
B00436-01
– Mount the dust cover for the air filter for sand.
Sand cover for air filter (59006022000)
Info
Read the KTM PowerParts installation instructions.
– Adjust the carburetor jetting and setting.
Info
Your authorized KTM workshop can recommend the right carburetor tuning.
600868-01
– Clean the chain.
Chain cleaner ( p. 127)
– Mount the steel sprocket.
Tip
Do not grease the chain.
– Clean the radiator fins.
– Carefully align bent radiator fins.
– If used in sand regularly, replace the piston every 10 operating hours.
7.5 Preparations for riding on wet sand
600872-10
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the displayed value does not equal the setpoint value:
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
– Change the radiator cap.
B00437-01
– Mount the rain cover for the air filter.
Rain cover for air filter (59006021000)
Info
Read the KTM PowerParts installation instructions.
– Adjust the carburetor jetting and setting.
Info
Your authorized KTM workshop can recommend the right carburetor tuning.
To Next Page
Need help?
General
