11 SERVICE WORK ON THE CHASSIS 56
B02100-11
(All 250/300 models)
– Raise the swingarm slightly, and carefully position the shock absorber in the
vehicle from the top.
–
Mount and tighten screw
.
Guideline
Screw, top shock
absorber
M10 60 Nm
(44.3 lbf ft)
Loctite
®
2701™
B02098-11
– Position the angle lever and linkage lever.
–
Mount and tighten screw cap
.
Guideline
Nut, linkage lever to angle lever M14x1.5 80 Nm (59 lbf ft)
–
Mount and tighten screw
.
Guideline
Screw, bottom shock
absorber
M10 60 Nm
(44.3 lbf ft)
Loctite
®
2701™
Finishing work
– Install the main silencer. ( p. 62)
– Remove the motorcycle from the lift stand. ( p. 44)
11.20 Removing the seat
M01156-10
(All 125/150 models)
–
Remove screws
.
– Raise the rear of the seat, pull the seat back, and lift it off.
M01188-10
(All 250/300 models)
–
Remove screw
.
– Raise the rear of the seat, pull the seat back, and lift it off.
11.21 Mounting the seat
M01157-01
(All 125/150 models)
– Mount the front seat on to the collar bushing of the fuel tank, lower it at the
rear, and simultaneously push it forward.
– Make sure that the seat is correctly locked in.
To Next Page
Loading...
Need help?
General
