15 COOLING SYSTEM 135
B01552-10
– Remove radiator cap 2.
– Check the coolant antifreeze.
−25… −45 °C (−13… −49 °F)
» If the coolant antifreeze does not meet specifications:
– Correct the coolant antifreeze.
– Check the coolant level in the radiator.
The radiator must be completely filled.
» If the coolant level does not meet specifications:
– Correct the coolant level and find out the cause of the loss.
Alternative 1
Coolant ( p. 171)
Alternative 2
Coolant (mixed ready to use) ( p. 171)
» If you had to add more coolant than the specified amount:
> 0.20 l (> 0.21 qt.)
–
Fill/bleed the cooling system. x ( p. 138)
– Mount the radiator cap.
15.3 Checking the coolant level
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
To Next Page
Loading...
Need help?
General
