TUNING THE ENGINE 153
15.4Adjusting the ignition curve to the fuel quality
– Switch off the ignition by turning the ignition key to the OFF position.
– Remove the seat. ( p. 81)
To activate the ignition curve for low octane fuel:
Note
Engine damage Low-quality fuel damages the engine.
– Operate the vehicle with fuel with an octane rating below 95 (ROZ 95 / RON 95 / PON 91) for no more than one tank full.
– The ignition curve must be adjusted to low octane fuel.
– Disconnect plug-in connector.
Plug-in connector disconnected – Fuel with an octane rating of 80 to 94 (RON) can be used for one tank full. ( p. 152)
Activate the ignition curve for fuel with an octane rating of 95 or higher (ROZ 95/RON 95/PON 91):
– Connect plug-in connector.
Plug-in connector connected – Fuel with an octane rating of 95 or higher can be used. ( p. 152)
– Mount the seat. ( p. 82)
15.5Checking the basic position of the shift lever
400692-10
– Sit on the vehicle in the riding position and determine the distance between the
upper edge of your boot and the shift lever.
Distance between shift lever and upper
edge of boot
10… 20 mm (0.39… 0.79 in)
» If the distance does not meet specifications:
–
Adjust the basic position of the shift lever. x ( p. 154)
To Next Page
Loading...
Need help?
General
