KTM 250 EXC TPI User Manual

COOLING SYSTEM 16
133
400243-10
–
Pour coolant in up to measurement
A
above the radiator fins.
Guideline
10 mm (0.39 in)
Coolant 1.2 l (1.3 qt.) Coolant ( p. 166)
E00904-10
–
Push protection cap
2
upward over the thermostat.
E00905-10
–
Unplug connector
3
.
–
Remove thermostat
4
with O-ring and wait until the coolant
escapes without bubbles.
–
Mount thermostat
4
with the O-ring and tighten.
Guideline
Screw, cylinder head
temperature sensor
M10x1.25 12 Nm (8.9 lbf ft)
–
Plug in connector
3
.
–
Position protection cap
2
.
400243-10
–
Pour coolant in up to measurement
A
above the radiator fins.
Guideline
10 mm (0.39 in)
Coolant ( p. 166)
E00906-10
–
Mount radiator cap
5
.
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation
when running the engine.
– Use effective exhaust extraction when starting or
running the engine in an enclosed space.
– Allow the engine to warm up and cool down again.

KTM 250 EXC TPI Specifications

General

Displacement	249 cm³
Cooling	Liquid cooled
Transmission	6-speed
Starter	Electric starter
Front Brake	Disc brake
Rear Brake	Disc brake
Ground Clearance	370 mm
Seat Height	960 mm
Bore x Stroke	66.4 mm x 72 mm
Engine Type	1-cylinder, 2-stroke
Fuel System	TPI
Front Suspension	WP XPLOR-USD, Ø 48 mm
Rear Suspension	WP Xplor shock absorber
Fuel Capacity	9 l
Frame	Central tube frame made of chrome molybdenum steel