18 SERVICE WORK ON THE ENGINE
144
S03513-10
–
Check whether air bubbles are visible in the hose
6
.
» If air bubbles are visible:
– Repeat the entire procedure until air bubbles are no
longer visible.
– Mount protection cap on the diagnostics connector.
–
Mount the EFI control unit on the rubber lugs.
Finishing work
– Mount the seat. ( p. 79)
18.4 Cleaning the oil screen in the oil tank
Note
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 65)
– Remove the main silencer. ( p. 83)
– Remove the seat. ( p. 79)
– Remove the fuel tank. ( p. 84)
– Remove the air filter box cover. ( p. 80)
S03507-10
Main work
–
Remove screw
1
with the washer.
– Remove the cable ties and take off the frame protector.
S03502-10
–
Remove screws
2
.
–
Loosen screws
3
.
To Next Page
Loading...
Need help?
General
