To Next Page

To Previous Page

TUNING THE ENGINE 16

115

Info

If there is a big engine speed rise, reduce the idle

speed to a normal level and repeat the above steps.

If the procedure described here does not lead to sat-

isfactory results, the cause may be a wrongly dimen-

sioned idling jet.

If you can turn the idle air adjusting screw to the end

without any change of engine speed, mount a smaller

idling jet.

After changing the jet, start from the beginning with

the adjusting steps.

Following extreme air temperature or altitude changes,

adjust the idle speed again.

16.6 Plug-in connector of ignition timing map adjustment

K01214-10

(All SX models)

Plug-in connector

of the ignition timing map adjustment is

located on the frame under the fuel tank.

K01217-10

(All XC models)

Plug-in connector

of the ignition timing map adjustment is

located on the frame under the fuel tank.

Possible states

(All SX models)

• Soft – The plug-in connector of the ignition timing map

adjustment is disconnected to achieve better rideability.

• Performance – The plug-in connector of the ignition tim-

ing map adjustment is joined to achieve higher perfor-

mance.