KTM 250 SX 2019 User Manual

16 TUNING THE ENGINE
116
16.7 Changing the ignition timing map
Switching the ignition timing map from Performance to Soft
(All SX models)
–
Disconnect plug-in connector
1
of the ignition timing map adjustment.
(Figure K01214-10 p. 115)
Soft – better rideability
(All XC models)
–
Disconnect plug-in connector
1
of the ignition timing map adjustment.
(Figure K01217-10 p. 115)
Soft – better rideability
Switching the ignition timing map from Soft to Performance
(All SX models)
–
Join plug-in connector
1
of the ignition timing map adjustment. (Figure K01214-10 p. 115)
Performance – better performance
(All XC models)
–
Join plug-in connector
1
of the ignition timing map adjustment. (Figure K01217-10 p. 115)
Performance – better performance
16.8 Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
400692-10
– Sit on the vehicle in the riding position and determine
distance
A
between the upper edge of your boot and the shift
lever.
Distance between shift lever
and upper edge of boot
10 … 20 mm (0.39 …
0.79 in)
» If the distance does not meet specifications:
– Set the basic position of the shift lever. ( p. 116)
16.9 Adjusting the basic position of the shift lever
401950-12
–
Remove screw
1
with the washers and take off shift
lever
2
.

KTM 250 SX 2019 Specifications

General

Brand	KTM
Model	250 SX 2019
Category	Motorcycle
Language	English