PREPARING FOR USE 15
– Do not exceed the overall maximum permitted weight and the axle loads.
Guideline
Maximum permissible overall weight 335 kg (739 lb.)
Maximum permissible front axle load 145 kg (320 lb.)
Maximum permissible rear axle load 190 kg (419 lb.)
– Run in the engine. ( p. 15)
6.2Running in the engine
– During the running-in phase, do not exceed the specified engine speed and engine performance.
Guideline
Maximum engine speed
During the first operating hour 7,000 rpm
Maximum engine performance
During the first 3 service hours ≤ 75 %
– Avoid fully opening the throttle!
6.3Preparing the vehicle for difficult riding conditions
Info
Using a motorcycle in difficult conditions can lead to excessive wear of components such as the power train or brakes. For this
reason, it may be necessary to service or replace worn parts before the limit specified in the service schedule is reached.
– KTM recommends that you use the specified engine oil for difficult riding conditions and to increase performance.
Engine oil (SAE 10W/60) (00062010035) ( p. 90)
–
Seal the air filter box. x
Tip
Seal the air filter box at the edges against dirt.
–
Clean the air filter and air filter box. x ( p. 41)
Info
Check the air filter approx. every 30 minutes.
– Additionally secure the rubber grip. ( p. 49)
– Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion or damage is found:
– Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
– Rides on dry sand. ( p. 15)
– Rides on wet sand. ( p. 16)
– Rides on wet and muddy surfaces. ( p. 16)
– Rides at high temperatures and low speeds. ( p. 17)
– Rides at low temperatures or in snow. ( p. 17)
6.4Preparing for rides on dry sand
B00435-01
– Fit a dust protection device on the air filter.
Dust protection device for air filter (77206920000)
Info
See the KTM PowerParts fitting instructions.
To Next Page
Loading...
Need help?
General
