WHEELS, TIRES 60
B00302-11
– Mount and tighten screw .
Guideline
Screw, front wheel spindle M24x1.5 45 Nm
(33.2 lbf ft)
– Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
– Remove the motorcycle from the lift stand. ( p. 31)
– Pull the front brake and compress the fork powerfully a few times.
The fork legs straighten.
– Tighten screws .
Guideline
Screw, fork stub M8 15 Nm
(11.1 lbf ft)
12.3Removing the rear wheel x
– Raise the motorcycle with the lift stand. ( p. 31)
B00340-10
– Press the brake caliper onto the brake disc by hand in order to push back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
– Remove nut .
– Remove chain adjuster . Withdraw wheel spindle only enough to allow the rear
wheel to be pushed forward.
– Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
– Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swing arm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
B00341-10
– Remove spacers .
12.4Installing the rear wheel x
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
– Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
To Next Page
Loading...
Need help?
General
