SERVICE WORK ON THE CHASSIS 48
10.39Adjusting the chain guide x
B00348-10
– Loosen screw . Remove screw . Swing the chain guide down.
Condition
Number of teeth: ≤ 44 teeth
– Insert collar bushing in hole . Position the chain guide.
– Mount and tighten screw . Tighten screw .
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
Condition
Number of teeth: ≥ 45 teeth
– Insert collar bushing in hole . Position the chain guide.
– Mount and tighten screw . Tighten screw .
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
10.40Checking the frame x
500284-01
– Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame. x
Info
A frame that has been damaged due to a mechanical impact must
always be changed. Repair of the frame is not authorized by KTM.
10.41Checking the swingarm x
500285-01
– Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm. x
Info
A damaged swingarm must always be changed. Repair of the
swingarm is not authorized by KTM.
10.42Checking the throttle cable routing
–
Remove the fuel tank. x ( p. 42)
101286-10
– Check the throttle cable routing.
Both throttle cables must be routed to the throttle valve body side by side behind
the handlebars and above the tank bearing.
» If the throttle cable is not routed as specified:
– Correct the throttle cable routing.
–
Install the fuel tank. x ( p. 43)
To Next Page
Loading...
Need help?
General
