11 SERVICE WORK ON THE CHASSIS
56
K01014-11
–
Position the brake caliper. Mount and tighten screws
4
.
Guideline
Screw, front
brake caliper
M8 25 Nm (18.4 lbf ft)
Loctite
®
243™
– Position the brake line and the clamp. Mount and tighten
screws
5
.
Finishing work
– Install the front wheel. ( p. 102)
11.11 Removing the lower triple clamp
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 51)
– Remove the front wheel. ( p. 101)
– Remove the fork legs. ( p. 54)
– Remove the start number plate. ( p. 62)
– Remove front fender. ( p. 63)
– Remove the handlebar cushion.
F01561-10
Main work
(SX‑F EU/US, XC-F US)
–
Open cable holder
1
on the left and detach the wiring
harness.
–
Remove screw
2
.
–
Remove screw
3
.
– Take off the upper triple clamp with the handlebar and
place to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
A00723-10
(XC‑F US KAILUB RUSSELL)
–
Open cable holder
1
on the left and detach the wiring
harness.
–
Remove screw
2
.
–
Remove screw
3
.
– Take off the upper triple clamp with the handlebar and
place to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
To Next Page
Loading...
Need help?
General
