WHEELS, TIRES 15
177
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
– Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
Finishing work
– Check the chain tension. ( p. 142)
– Remove the rear of the motorcycle from the lifting gear.
( p. 130)
15.5 Checking the rear hub rubber dampers
Info
The engine power is transmitted from the rear sprocket to the rear wheel via 6 rubber dampers. They even-
tually wear out during operation. If the rubber dampers are not changed in time, the rear sprocket carrier
and the rear hub become damaged.
Preparatory work
– Raise the motorcycle with the rear lifting gear. ( p. 130)
– Remove the rear wheel. ( p. 171)
To Next Page
Loading...
Need help?
General
