KTM 85 SX 2021 User Manual

11 SERVICE WORK ON THE CHASSIS
52
H01167-01
Main work
– Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
– Adjust the steering head bearing play. ( p. 52)
– Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
– Adjust the steering head bearing play. ( p. 52)
– Check the steering head bearing and replace if
required.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 44)
11.12 Adjusting the steering head bearing play
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 44)
S03421-10
Main work
–
Pull fuel tank breather
1
out of the steering stem.
–
Loosen screws
2
.
–
Loosen screw
3
.
–
Loosen and retighten nut
4
.
Guideline
Nut, steering stem M20x1.5 10 Nm (7.4 lbf ft)
– Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
Tighten screw
3
.
Guideline
Steering stem clamp
screw
M8 20 Nm (14.8 lbf ft)
–
Tighten screws
2
.
Guideline
Screw, top triple
clamp
M8 17 Nm (12.5 lbf ft)
–
Position the fuel tank breather
1
in the steering stem.
Finishing work
– Check the steering head bearing play. ( p. 51)
–
Remove the motorcycle from the lift stand. ( p. 44)

KTM 85 SX 2021 Specifications

General

Brand	KTM
Model	85 SX 2021
Category	Motorcycle
Language	English