16 ELECTRICAL SYSTEM
98
16.11 Installing the cover of the headlight mask rack
V01219-10
Main work
– Position cover by guiding the plug-in connector of the head-
light through the opening.
–
Hold turn signal in the area
A
and carefully press against the
direction of travel, while pressing the cover tight at the same
time.
The cover engages with an audible click.
– Repeat the operation on the opposite side.
V01218-10
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M5 5 Nm (3.7 lbf ft)
–
Mount and tighten screws
2
.
Guideline
Screw, headlight EJOTPT
®
K50x14
3 Nm (2.2 lbf ft)
Finishing work
– Mount the headlight mask with the headlight. ( p. 96)
– Check the headlight setting. ( p. 98)
16.12 Checking the headlight setting
400726-10
– Position the vehicle upright on a horizontal surface in front of
a light wall and make a marking at the height of the center of
the low beam headlight.
–
Make another mark at a distance
B
under the first marking.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle perpendicular to the wall at a distance
A
from the wall and switch on the low beam.
Guideline
Distance
A
5 m (16 ft)
– The rider now mounts the motorcycle with luggage and passen-
ger if applicable.
– Check the headlight setting.
To Next Page
Loading...
Need help?
General
