Section 5: Maintenance & Lubrication
Table of Contents
AP-SC4060 & AP-SC4072 Skid Steer Rotary Cutters 326-765MK 12/14/18
28
Front Rollers
2 - Rollers
Type of Lubrication: Lithium based spray lubricant
Quantity = As required
In Line Bearing Housing Lubrication
39996
70012
Lubrication Points
50
Hrs
Multi-purpose
spray lube
Multi-purpose
grease lube
Multi-purpose
oil lube
Intervals in hours at which
lubrication is required
Lubrication
Legend
In Line Bearing Housing
The motor spindle hub has two 1/2" pipe plugs located
on top side of deck housing.
1. Disengage blade hydraulics. Make sure blades have
come to a complete stop.
2. Set cutter down on level ground.
3. Set park brake, shut engine off, and remove switch
key before continuing.
4. Remove 1/2" dip stick. The end of the dipstick should
have fluid on it. If it does not, add fluid.
5. Alternate method: Dip a tape measure 3/4" through
the hole as shown. The end of the tape measure
should have fluid on it. If it does not, add fluid.
6. Add EP 80-90 weight gearlube as required. Full
capacity of motor housing is approximately 10 oz.
7. Re-install dipstick and tighten.
8
Hrs.
As
Required
To Next Page
Loading...
Need help?
General
