OPERATING THE ENGINE12
C Check Easy Checker(TM) lamps:
1. When the key is turned "ON", lamps (3) (4) should
come on. If trouble should occur at any location while
the engine is running, the warning lamp corresponding
to that location comes on.
A Daily checks with the Easy Checker(TM) only are not
sufficient. Never fail to conduct physical daily checks
carefully by referring to "DAILY CHECK" section.
(See "DAILY CHECK" in "PERIODIC SERVICE"
section.)
4. Place the position control lever in
"LOWEST" position.
(1) Position control lever (A) "DOWN"
5. Set the throttle lever to about 1/2 way.
(1) Hand throttle lever "INCREASE"
"DECREASE"
6. Insert the key into the key switch and
turn it "ON".
"OFF"
"ON"
"PREHEAT"
"START"
(1) Easy checker(TM)
(2) Key switch
(3) Engine oil pressure
(4) Electrical charge
(5) Glow plug indicator
To Next Page
Loading...
Need help?
General
