13OPERATING THE ENGINE
For the appropriate preheating time, refer to the table
below:
A Glow plug indicator (5) comes on while engine is being
preheated.
A Because of the safety devices, the engine will not start
except when the PTO clutch lever is placed in the
"OFF" position and speed control pedal is placed in the
"NEUTRAL" position.
C Cold Weather Starting
When the ambient temperature is below -5 (23 ) and
the engine is very cold. If the engine fails to start, turn off
the key for 30 seconds. Then repeat steps 7 and 8. To
protect the battery and the starter, make sure that the
starter is not continuously turned for more than 30
seconds.
BBlock Heater (Option)
A block heater is available as an option from your dealer.
It will assist you in starting your tractor when the ambient
temperature is below -15 (5 )
If a lamp is still on, immediately stop the engine and
determine the cause.
STOPPING THE ENGINE
7. Turn the key to "PREHEAT" position
and hold it for about 2 to 3 seconds.
Temperature Preheating Time
Over 0 C (32 F) 2 to 3 sec.
0 to -5 C (32 to 23 F) 5 sec.
-5 to -15 C (23 to 5 F) 10 sec.
8. Turn the key to "START" position and
release when the engine starts.
9. Check to see that all the lamps on the
Easy Checker(TM) are "OFF".
1. After slowing the engine to idle, turn the
key to "OFF".
2. Remove the key.
To Next Page
Loading...
Need help?
General
