CAB OPERATION44
WIPER
BFront Wiper / Washer Switch
When the button marked is pressed to the first step,
the wiper only is activated.
When the button is pressed further to the second step,
washer liquid jets out.
The washing continues while the button is pressed and
wiper is activated continuously. (Washer liquid jets out to
the rear window also.)
Hold down the bottom half of the switch when the front
wiper is off, and washer liquid will keep jets out.
To wet the glass before activating the wipers, press the
bottom half of the switch. (Washer liquid jets out to the
rear window also.)
BRear Wiper Switch
1. Press the upper half of the wiper switch, and the wiper
is activated. Press the lower half of the wiper switch,
and the wiper stops at the initial position.
2. To jet washer liquid, push the front wiper / washer
switch. (Washer liquid jets out to the front window
also.)
A Do not activate the wipers when the windows are dry,
they may be scratched.
Be sure to jet washer liquid first and then activate the
wipers.
BUsing the Wipers in Cold Season
1. While not used in cold season, keep the wiper blades
off the windshield to prevent them from being stuck
with ice.
2. If the windshield is covered with snow, scrape it off the
windshield before using the wipers.
3. If the wiper blades are stuck on the windshield with ice
and fail to move, be sure to turn the main key switch to
"OFF" and remove the ice off the blades. Then place
the main key switch back to "ON".
4. When commercially available cold-season wiper
blades are used, make sure their size is the same as
or smaller than that of the standard ones.
A In cold season, the wiper blades and the wiper motor
might get overloaded causing damage. To avoid this,
be sure to take the above precautions.
(1) Front wiper / washer switch
(1) Rear wiper switch
To Next Page
Loading...
Need help?
General
