PTO42
BPTO shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times. Replace
the PTO shaft cap when the PTO is not in use. Before
connecting or disconnecting a drive shaft to PTO shaft, be
sure the engine is "OFF" and raise up the PTO shaft
cover.
Afterward be sure to return the PTO shaft cover to the
"NORMAL POSITION".
A The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
BLCD Monitor Message
1. The PTO rpm can be checked in the LCD monitor.
(See "LCD MONITOR" in "OPERATING THE
TRACTOR" section.)
A With the PTO in the "ON" position, a numeric value is
displayed on the LCD monitor even if the PTO shaft is
not turning.
(1) PTO shaft cover
(2) PTO shaft cap
(A) "NORMAL POSITION"
(B) "RAISED POSITION"
(1) LCD monitor
(2) PTO indicator
(3) PTO speed
To Next Page
Loading...
Need help?
General
