3-POINT HITCH & DRAWBAR46
3-POINT HITCH
BSelecting the holes of lifting rods and
lower links
There are 2 holes in the lower links. For most operations
the lifting rods should be attached to the (A) holes.
A The lifting rods may be attached to (B) hole for higher
lifting height. (with reduced lifting force)
BSelecting the Top Link Mounting Holes
Select the proper set of holes by referring to the
"Hydraulic Control Unit Use Reference Chart" in
"HYDRAULIC UNIT" section.
BDrawbar
Remove the drawbar if a close mounted implement is
being attached.
To avoid personal injury or death:
A Be sure to stop the engine and remove the key.
A Do not stand between tractor and implement
unless parking brake is applied.
A Before attaching or detaching implement,
locate the tractor and implement on a firm, flat
and level surface.
A Whenever an implement or other attachment is
connected to the tractor 3-point hitch, check
full range of operation for interference, binding
or PTO driveline separation.
1. Make preparations for attaching
implement.
(1) Lower links
(2) Lifting rods
holes:(A),(B)
(1) Mounting hole 1
(2) Mounting hole 2
2. Attaching and detaching implements
To Next Page
Loading...
Need help?
General
