77PERIODIC SERVICE
BCleaning Grill and Radiator Screen
To avoid personal injury or death:
A Be sure to stop the engine before removing the
screen.
A The condenser and receiver become hot while
the air conditioner is running. Before checking
or cleaning them, wait long enough until they
cool down.
1. Check front grill and side screens to be sure they are
clean of debris.
2. Detach the screen and remove all foreign material and
clean the front of radiator completely.
A Grill and screen must be clean from debris to prevent
engine from overheating and to allow good air intake
for the air cleaner.
BChecking Brake Pedal
1. Inspect the brake pedals for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Brake Pedal" in "EVERY 100 HOURS"
in "PERIODIC SERVICE" section.)
BChecking Gauges, Meter and Easy
Checker(TM)
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker(TM).
2. Replace if broken.
BChecking Head Light, Hazard Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
BChecking Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating tractor.
2. Replace if damaged.
BChecking and Cleaning of Electrical
Wiring and Battery Cables
To avoid personal injury or death:
A A loosened terminal or connector, or damaged
wire may affect the performance of electrical
components or cause short circuits. Leakage
of electricity could result in a fire hazard, a
dead battery or damage to electrical
components.
A Replace damaged wires or connections
promptly.
A If a fuse blows soon after replacement, DO NOT
USE A LARGER THAN RECOMMENDED FUSE
OR BYPASS THE FUSE SYSTEM.
A Many wiring connections are protected by
waterproof plugs, plug and unplug these
connections carefully and make sure they are
sealed correctly after assembly.
A Accumulation of dust, chaff or spilled fuel
deposits around the battery, electrical wiring,
engine or exhaust system are a fire hazard.
CLEAN THESE AREAS BEFORE STARTING
WORK.
To avoid premature electrical malfunctions DO
NOT APPLY high pressure water directly to
battery, wiring, connectors, electrical
components or instrument panel.
Inspect the following Regularly:
1. Check wiring for chafed or cracked insulation.
2. Check wiring harness clamps. Replace if necessary.
3. Check connectors and terminals for looseness,
contamination or overheated (discolored)
connections.
4. Check instrument panel for correct operation of
switches and gauges.
Consult your Kubota Dealer regarding maintenance,
diagnosis and repair.
BChecking Movable Parts
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or sticky material, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky material,
and apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
(1) Radiator screen (A) "DETACH"
To Next Page
Loading...
Need help?
General
