EasyManua.ls Logo

Kubota BX231D User Manual

Kubota BX231D
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
3. Cleaning the transmission strainer
1. When changing the transmission fluid, disassemble
and rinse the transmission strainer with non-
flammable solvent to completely clean off filings.
When reassembling the transmission strainer, be
careful not to damage the parts.
(1) Transmission strainer (2) Filter plate
NOTE :
Since the fine filings in the oil can damage
the precision component parts of the
hydraulic system, the end of the suction line
is provided with an oil strainer.
4. Changing the front axle case oil
WARNING
To avoid serious injury or death:
Be sure to stop the engine and remove the key
before changing the front axle case oil.
Oil capacity 3.6 L
1. Park the tractor on a firm, flat, and level place.
2. To drain the used front-axle-case-oil, remove the
right and left drain plugs and oil gauge at the front
axle case. See the following figure.
See the following figure.
3. Drain the front-axle-case-oil completely into the oil
pan.
4. After draining the front-axle-case-oil, reinstall the
drain plugs.
5. Remove the right and left breather plugs.
6. Fill with new front-axle-case-oil up to the upper
notch on the dipstick.
(See LUBRICANTS, FUEL AND COOLANT on
page 84)
IMPORTANT :
After the following minutes, check the front-
axle-case-oil level again. If the front-axle-
case-oil level is lower than the prescribed
level shown in the following figure, add the
front-axle-case-oil to prescribed level.
Checking the front axle case oil level
10 minutes after filling with
new front axle case oil
7. After filling with front-axle-case-oil, reinstall the oil
gauge and breather plugs.
(1) Breather plug
(2) Oil gauge with dipstick
(3) Drain plug
(A) Front axle case oil level is
acceptable within this range
5. Replacing the fuel filter element
Consult your local KUBOTA Dealer for replacing the
fuel filter element.
SERVICE EVERY 800 HOURS
1. Adjusting the engine valve
clearance
Consult your local KUBOTA Dealer for adjusting the
clearance of the engine valve.
SERVICE EVERY 400 HOURS  PERIODIC SERVICE
BX231D
101

Table of Contents

Questions and Answers:

Kubota BX231D Specifications

General IconGeneral
BrandKubota
ModelBX231D
CategoryTractor
LanguageEnglish

Related product manuals