2. Push the front-hydraulic-valve-main-switch onto on.
3. Press the
activation switch and move the loader
lever to left and right several times.
4. Push the front hydraulic valve main switch onto off.
5. Turn the key switch to the off position.
Connecting
1. Clean both couplers of the implement and tractor.
2. Remove the dust plugs.
3. Insert the remote-control-coupler of the implement
to the hydraulic coupler of the tractor.
4. Pull the remote-control-coupler of the implement
slightly to make sure that both couplers of the
implement and tractor are firmly connected.
NOTE :
• Your local KUBOTA dealer can supply parts to
adapt couplers to hydraulic hoses.
Disconnecting
1. Lower the
implement first to the ground to release
hydraulic pressure in the hoses.
2. Clean both couplers of the implement and tractor.
3. Press the activation switch and move the loader
lever to left and right several times to relieve
hydraulic pressure.
4. Pull the hose straight from the hydraulic coupler to
release it.
5. Clean oil and dust from the hydraulic coupler, and
then replace the dust plugs.
FRONT GUARD (OPTION FOR
THE QUICK ATT
ACH COUPLER)
(1) Front guard
1. How to use the front guard (if
equipped)
Attaching the front guard
1. Attach the front guard in position on the tractor
.
(1) Front guard
(2) Front guard plate
(3)
4-M12 x 35 flange bolt
(4) 4-M12 spring washer (nut
side)
(5) 4-M12 nut
IMPORTANT :
• Before moving
the tractor or the front loader,
make sure that the front guard is tightly
fastened.
Opening the upper front guard
1. Lower the boom to the ground with the bucket in
level position.
IMPORTANT :
• Lower the front loader to the ground before
opening the upper front guard.
• Do not raise the boom while the upper front
guard is open.
2. Hold the handle part and pull the front guard
forward.
OPERATING THE LOADER FRONT GUARD (OPTION FOR THE QUICK ATTACH COUPLER)
To Next Page
Loading...
Need help?
General
