Kubota BX23S User Manual

4. Front distance should be the length as shown in the
following table. If front distance is not proper length,
adjust the length of the tie rod.
To adjust the tie rod, see 4.1 Adjusting the toe-in on
page 131.
Front distance
0 mm to 5 mm (0 in. to 0.2 in.) less than
rear distance
(A) Wheel-to-wheel distance at
rear
(B) Wheel-to-wheel distance at
front
(C) Front
4.1 Adjusting the toe-in
1. Loosen the lock nut and turn the tie rod to adjust
the rod length until the proper toe-in measurement
is obtained.
Front distance
0 mm to 5 mm (0 in. to 0.2 in.) less than
rear distance
2. Retighten the lock nut.
(1) Lock nuts (2) Tie rod
SERVICE OF THE TRACTOR
EVERY 400 HOURS
1. Adjusting the front axle pivot
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
before adjusting the front axle pivot.
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the
steering wheel.
1. Remove the split pin and tighten the adjusting nut.
Tightening torque
20 N⋅m
(2.0 kgf⋅m)
(15 lbf⋅ft)
2. Make sure that one of the nut slots aligns with the
split pin hole.
3. Tighten the nut slightly if necessary when aligning
the nut slots with the split pin hole.
4. Replace the split pin.
(1) Adjusting nut (2) Split pin
2. Changing the transmission fluid
WARNING
To avoid serious injury or death:
• Oil can be hot and can burn. Allow the engine to
cool down sufficiently.
Transmission fluid KUBOTA SUPER UDT
Transmission fluid capacity
11.6 L
(3.1 U.S.gals.)
1. To drain the used transmission fluid, remove the
drain plug at the bottom of the transmission case
and drain the transmission fluid completely into the
oil pan.
SERVICE OF THE TRACTOR EVERY 200 HOURS
PERIODIC SERVICE OF THE TRACTOR
BX23S, LA340, BT603
131

Kubota BX23S Specifications

General

Brand	Kubota
Model	BX23S
Category	Tractor
Language	English