3. Place the speed-set-rod in the off position.
(1) Speed set rod
(A) On
(B)
Off
4. Place
the
speed-control-pedal in the neutral
position.
(1) Speed control pedal
NOTE :
• The
speed-control-pedal
automatically
returns to the neutral position when the
operator's foot is released from the speed-
control-pedal.
5. Place the range-gear-shift-lever (Hi-Lo) in the
neutral “N” position.
(1) Range gear shift lever (Hi-
Lo)
(A)
Low
(B)
Neutral
(C) High
6. Lock
the loader-control-lever in the lock
position if
equipped.
(1) Loader control lever
(2) Lock lever
(A)
Lock
7. Move
the
hydraulic-control-lever forward (the
lowered (down)
position) to lower the
implement.
(1) Hydraulic control lever
(A) Raised
(B)
Lowered
(N) Neutral position
Check that the implement is down at the lowest
position after
moving the hydraulic-control-lever
forward.
OPERATING THE ENGINE STARTING THE ENGINE
To Next Page
Loading...
Need help?
General
