43PERIODIC SERVICE
EVERY 200 HOURS
BReplacing Engine Oil Filter Cartridge
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing the oil and the oil filter
cartridge.
A Allow engine to cool down sufficiently; oil can
be hot and may cause burns.
1. Remove the oil filter.
2. Put a film of engine oil on the rubber seal of the new
filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
4. Tighten the filter by hand an additional 1/2 turn only.
5. After the new filter is replaced, the engine oil normally
decreases a little. Check that the engine oil does not
leak through the seal and be sure to check the oil level
on the dipstick.
6. Then, replenish the engine oil up to the prescribed
level.
A To prevent serious damage to the engine, use only a
genuine KUBOTA filter.
BChanging Transmission Fluid
To avoid personal injury:
A Be sure to stop the engine and remove the key
before changing or checking the oil.
A Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
The fluid in the transmission case is also used for the
hydrostatic drive system.
1. To drain oil, remove the drain plug at the bottom of the
transmission case and drain oil completely into the oil
pan.
2. After draining, reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
4. After running the engine for a few minutes, stop it and
check the oil level again; add oil to the prescribed
level.
(1) Engine oil filter cartridge
Oil capacity 14 L (14.8 U.S.qts.)
(1) Oil level dipstick
(2) Oil inlet
(A) Oil level is acceptable
within this range
To Next Page
Loading...
Need help?
General
