PERIODIC SERVICE48
EVERY 1 YEAR
BReplacing Air Cleaner Element
Change the element once a year.
BFlush Cooling System and Changing
Coolant
To avoid personal injury:
A Do not remove the radiator cap when the
engine is hot. Then loosen cap slightly to the
stop to relieve any excess pressure before
removing cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, remove the drain plug, and then
the radiator cap. The radiator cap must be removed to
completely drain the coolant.
3. After all coolant is drained, install the drain plug.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until
the coolant level is just below the fill port on the
radiator.
Install the radiator cap securely.
7. Fill with coolant up to the "FULL" mark on the recovery
tank.
8. Start and operate the engine for a few minutes.
9. Stop the engine and let cool.
10.Check coolant level of recovery tank and add coolant
if necessary.
A Do not start engine without coolant.
A Use clean, distilled water and anti-freeze to fill the
radiator and recovery tank.
A When the anti-freeze is mixed with water, the anti-
freeze mixing ratio must be less than 50%.
A Securely tighten radiator cap. If the cap is loose or
improperly fitted, water may leak out and the engine
could overheat.
BAnti-freeze
To avoid personal injury:
A When using anti-freeze, put on some protection
such as rubber gloves (Anti-freeze contains
poison.).
A If anti-freeze is ingested, induce vomiting at
once and seek medical attention.
A When anti-freeze comes in contact with the
skin or clothing, wash it off immediately.
A Do not mix different types of Anti-freeze. The
mixture can produce chemical reaction
causing harmful substances.
A Anti-freeze is extremely flammable and
explosive under certain conditions. Keep fire
and children away from anti-freeze.
A When draining fluids from the engine, place
some container underneath the engine body.
A Do not pour waste onto the grounds, down a
drain, or into any water source.
A Also, observe the relevant environmental
protection regulations when disposing of anti-
freeze.
(1) Drain plug
Coolant capacity 4.6 L (4.9 U.S.qts)
Recovery tank capacity 0.6 L (0.6 U.S.qts)
(1) Clamp
(2) Recovery tank
(3) Recovery tank cap
(A) "FULL"
(B) "LOW"
To Next Page
Loading...
Need help?
General
