GENERAL
G23, G26, WSM
G-20
(EU)
(6) Others
1. Check the areas where previous trouble was experienced.
9Y1210294GEG0018US0
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
To avoid personal injury :
• Be sure to stop the engine and remove the key before
changing the oil.
• Allow engine to cool down sufficiently; oil can be hot and
may cause burns.
1. To drain the used oil, remove the drain plug at the bottom of the
engine and drain the oil completely into the oil pan.
All the used oil can be drained out easily when the engine is still
warm.
2. After draining, reinstall the drain plug (3).
3. Fill with the new oil up to the upper notch on the dipstick (2).
(Refer to "LUBRICANTS, FUEL AND COOLANT" in this
section.)
4. Properly dispose of used oil.
9Y1210294GEG0019US0
Replacing Engine Oil Filter
To avoid personal injury :
• Be sure to stop the engine and remove the key before
changing the oil and the oil filter.
• Allow engine to cool down sufficiently; oil can be hot and
may cause burns.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly until contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, replenish the engine oil up to the prescribed
level.
5. Properly dispose of used oil.
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
9Y1210294GEG0020US0
Oil capacity with filter
G23
3.1 L
3.3 U.S.qts
2.7 Imp.qts
G26
3.5 L
3.7 U.S.qts
3.1 Imp.qts
(1) Oil Inlet
(2) Dipstick
(3) Drain Plug
(4) Front Tyre (LH)
A : Oil lever is acceptable within this
range.
(1) Engine Oil Filter
To Next Page
Loading...
Need help?
General
