ENGINE
G23, G26, WSM
1-S16
(EU)
Checking Valve Clearance
• Valve clearance must be checked and adjusted when
engine is cold.
1. Remove the cylinder head cover and the glow plugs.
2. Align the "1TC" mark (1) on the flywheel and alignment mark (2)
on the rear end plate so that the No. 1 piston comes to the
compression top dead center.
3. Check the following valve clearance marked with "+" using a
feeler gauge.
4. If the clearance is not within the factory specifications, adjust
with the adjusting screw.
5. Then turn the flywheel 6.28 rad (360 °) and align the "1TC"
mark (1) on the flywheel and alignment mark (2) on the rear end
plate so that the No.1 piston comes to the overlap position.
6. Check the following valve clearance "," using a feeler gauge.
7. if the clearance is not with in the factory specifications, adjust
with the adjusting screw.
Valve clearance marked with "+" can be adjusted.
• The sequence of cylinder numbers is given as No. 1, No. 2
and No. 3 starting from the gear case side.
• After adjusting the valve clearance, secure the adjusting
screw with the lock nut.
9Y1210294ENS0006US0
Adjustable cylinder location of
piston
Number of cylinder valve arrangement
Intake valve Exhaust valve
No. 1 ++
No. 2 ,+
No. 3 +,
Intake and exhaust valve
clearance (cold)
Factory specification
0.145 to 0.185 mm
0.00571 to 0.0728 in.
(1) 1TC Mark
(2) Alignment Mark
A : Gear Case Side
To Next Page
Loading...
Need help?
General
