67PTO
C PTO Clutch Indicator
The PTO clutch indicator turns on while PTO clutch
control switch is in "ON" (Engage) position.
BPTO Gear Shift Lever
To avoid personal injury:
A Be sure to observe the PTO shaft speed
prescribed for the individual implements. It is
extremely dangerous to run an implement at
high speed that is meant to be operated at low
speed. Use only when this higher rpm is
specifically recommended by the implement
manufacturer.
The PTO gear shift lever can be set to either 540 rpm or
1000 rpm positions.
Move this lever to either position with the PTO clutch
control switch set to "OFF".
A For maximum PTO shaft speeds of various
implements, see the implement Operator's Manual.
A Whenever the PTO speed is changed to the other
speed, it is necessary to switch the PTO speed display
mode of the side digital display. Otherwise the PTO
speed will not get correctly displayed in the side digital
display. (See "SIDE DIGITAL DISPLAY" in
"OPERATING THE TRACTOR" section.)
(1) PTO clutch indicator
PTO 540 / 1000 rpm model
(1) PTO gear shift lever (A) 540 rpm
(B) 1000 rpm
(N) "NEUTRAL" position
(1) Side digital display (A) "PTO SPEED"
To Next Page
Loading...
Need help?
General
