71PERIODIC SERVICE
BReplacing Transmission Oil Filter
[SUCTION]
To avoid serious injury:
A Be sure to stop the engine before changing the
oil filter.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface.
2. Remove the rear guard.
3. Remove the oil filter and old seal.
4. Put a film of clean transmission oil on the rubber seal
of the new filter.
5. Quickly tighten the filter by hand until it contacts the
mounting surface, then, with a filter wrench, tighten it
an additional 1/2 turn only.
6. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
7. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
8. Make sure that the transmission fluid doesn't leak past
the seal on the filters.
9. Install the rear guard, and the hose guard.
A To prevent serious damage to the transmission, use
only a KUBOTA genuine filter.
BChanging Hydraulic Tank Oil
To avoid serious injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a level surface.
2. Open the seat and remove the utility box.
3. Remove the rubber cap.
4. To drain the used oil, remove the drain plug and filling
plug and drain the oil completely into the oil pan.
5. After draining, reinstall the drain plug.
6. Fill with new prescribed oil up to the upper line on the
dipstick.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
How to check:
Wipe dipstick clean with a rag and screw it into filling
hole. Remove dipstick again to see if the oil level is
between the upper and lower line.
7. After filling, reinstall the filling plug.
8. Properly dispose of used filter.
(1) Transmission oil filter (Suction) (Black color)
(2) Rear guard
Oil Capacity 18.0 L (19.0 U.S.qts.)
(1) Drain plug
To Next Page
Loading...
Need help?
General
