(1) OFF
The position where the key can be inserted into or
removed from the key switch. When the key is
turned to this position, the engine shuts off.
(2) ON
The engine is running.
(3) START
Depress the brake pedal fully and push the PTO
switch to the “DISENGAGED” position, turn the key
switch to this position to start the engine.
5. Cold weather starting
If the ambient temperature is below 0 ℃ (32 ℉) and the
engine is very cold, start it in the following manner:
1. Use the choke.
2. Turn the key switch to the “START” (
) position.
• Operate starter 5 seconds.
• If engine does not start, wait 10 seconds.
• Repeat this procedure until engine starts.
3. When the engine starts, release key to “ON” ( )
position.
4. Move the throttle lever to “HALF SPEED” position.
IMPORTANT :
• When the temperature is below 0 ℃ (32 ℉).
Keep the engine at medium speed to warm
up the lubricant of engine and transmission
at least 10 minutes. If the machine is
operated before the lubricant of engine and
transmission is warmed sufficiently, the
machine life will be shortened.
• Do not operate the machine under full load
condition until it is sufficiently warmed up.
STOPPING THE ENGINE
1. Keep the engine at 1/2 to 3/4 throttle and turn the
key switch to the “OFF” position.
2. Remove the key.
3. Do not leave the key switch “ON” (key in the “ON”
position) as the battery will discharge when the
engine is not running.
4. Set the parking brake.
(1) Brake pedal
(2) Parking brake lock knob
(A) “DEPRESS”
(B) “PULL”
5. Close the fuel valve.
(1) Fuel valve (A) “OPEN”
(B) “CLOSE”
CHECKING SAFETY SYSTEMS
1. Checking engine start system
The engine start system in your machine is designed to
protect you while operating. Check the engine start
system periodically. It is recommended to check the
engine start system before daily operation.
WARNING
To avoid serious injury or death:
• Do not allow anyone near the machine while
testing.
• If the machine does not pass one of the
following tests, do not operate the machine.
Consult your local KUBOTA Dealer.
• Sit on operator's seat for all tests.
OPERATING THE ENGINE STARTING THE ENGINE
T2090BR-AU,T2290KW-AU,T2290KWT-AU
To Next Page
Loading...
Need help?
General
