No. Check item
Ref.
page
Mower
2
Check blades for wear or
damage.
61
3 Check all hardware. -
4
Make sure all pins are in
place.
21
While sitting in
the operator's
seat
1
Speed control pedal
Brake pedal
29,
47
2 Parking brake 47
Turning the key
switch “ON”
1 Headlights 61
Starting the en-
gine
1 Color of the exhaust fumes 70
2
Engine start system, OPC
system, PTO control sys-
tem. If either of these do not
operate properly, contact
your local KUBOTA Dealer
immediately.
24,
25,
25
3
Check for abnormal noise
and vibration.
-
Others
1
Check the areas where pre-
vious trouble was experi-
enced.
-
1. Checking the engine oil level
WARNING
To avoid serious injury or death:
• Always stop the engine and remove the key
before checking the oil.
Oil level check
1. Check engine oil before starting the engine or 5
minutes or more after the engine has stopped.
2. Wipe dipstick area clean.
3. To check the oil level.
T2290KW, T2290KWT
Remove the dipstick, wipe it clean, replace it and
draw it out again. Check to see that the oil level is
between the 2 marks.
(1) Engine oil port
(2) Oil level dipstick
(A) “UPPER LEVEL”
(B) “LOWER LEVEL”
T2090BR
Remove the dipstick, wipe it clean, replace it, and
draw it out again. Check to see that the oil level is
between the 2 marks.
(1) Engine oil port
(2) Oil level dipstick
(A) “UPPER LEVEL”
(B) “LOWER LEVEL”
4. Add new oil to the prescribed level at the oil port if
necessary.
IMPORTANT :
• When using a different brand or viscosity oil
from the previous one, remove all of the old
oil. Never mix 2 different types of oil.
• Use the proper SAE engine oil according to
the ambient temperature.
(See LUBRICANTS AND FUEL on page 40.)
2. Checking the amount of fuel and
refueling
WARNING
To avoid serious injury or death:
• Handle the fuel carefully. If the engine is
running, do not fill the fuel tank. If the engine is
hot, let the engine cool down several minutes
before adding fuel.
DAILY CHECK PERIODIC SERVICE
T2090BR-AU,T2290KW-AU,T2290KWT-AU
To Next Page
Loading...
Need help?
General
