(1) Air cleaner cover
(2) Air cleaner paper element
(A) Air intake hose
3. Replace a dirty, bent, or damaged element with a
genuine part. Handle the new element carefully; do
not use if the sealing surfaces are bent or
damaged.
(1) Air cleaner paper element (A) Air intake hose
4. Clean the air cleaner base as required and check
condition.
(B) Air cleaner base
5. Install the air cleaner paper element into the air
intake hose, and reinstall them in place.
6. Close the air cleaner cover.
NOTE :
• Operating the engine with loose or damaged
air cleaner components could allow
unfiltered air into the engine causing
premature wear and failure.
2. Replacing engine oil filter
WARNING
To avoid serious injury or death:
• Engine oil is a toxic substance. Dispose of used
oil properly. Contact your local authorities for
approved disposal methods or possible
recycling.
• Be sure to stop the engine and remove the key
before changing the oil and the oil filter
cartridge.
• Allow engine to cool down sufficiently; oil can
be hot and may cause burns.
The oil filter cartridge must be changed every 200
service hours.
Always use a genuine oil filter.
T2290KW, T2290KWT
1. Insert the hose attached with the machine to the T-
type pipe fitting on the oil filter side of the engine.
In the case of no hose attached, use the hydraulic
hose of inner diameter 0.5 in., length about
150 mm.
Direct the hose down, loosen the nut of the T-type
pipe fitting and drain the engine oil. Tighten the nut.
2. Remove the old filter and wipe off the filter adapter
with a clean cloth. After draining the oil, return the
nut of the t-type pipe fitting to its original position.
3. Place a new replacement filter in a shallow pan with
the open end up. Pour new oil, of the proper type,
in through the threaded center hole. Stop pouring
when the oil reaches the bottom of the threads.
Allow a minute or 2 for the oil to be absorbed by the
filter material.
4. Apply a thin film of clean oil to the rubber gasket on
the new oil filter.
5. Install the new oil filter to the filter adapter. Hand
tighten the filter clockwise until the rubber gasket
contacts the adapter, then tighten the filter an
additional 3/4-1 turn.
6. Fill the engine with the proper oil to the upper level
on the dipstick. Always check the oil level with the
dipstick before adding more oil.
7. Reinstall the oil fill cap/dipstick and tighten securely.
8. Start the engine and check for oil leaks. Recheck oil
level before placing the engine into service.
Stop the engine, correct any leaks, and allow a
minute for the oil to drain down, then recheck the
level on the dipstick.
EVERY 200 HOURS PERIODIC SERVICE
T2090BR-AU,T2290KW-AU,T2290KWT-AU
To Next Page
Need help?
General
