T2290KW, T2290KWT
(1) Pipe clamps
(2) Fuel line
(3) Fuel filter
2. Replacing spark plug
(See Checking spark plug on page 50.)
3. Checking engine valve clearance
Consult your local KUBOTA Dealer for this service.
EVERY 4 YEARS
1. Replacing fuel lines
This should be done by your local KUBOTA Dealer.
SERVICE AS REQUIRED
1. Replacing fuses
1. Open the hood.
2. Remove the blown fuse.
3. Place a new 3 A or 10 A fuse in position.
(1) Fuse location
(2) Slow blow fuse
(3) Battery
IMPORTANT :
• If the new fuse happens to blow out within a
short time, contact your dealer for inspection
and repair. Never “jump” the fuse with wire or
foil, etc.
Protected circuit
Fuse number
(id label)
Capacity (A) Protected circuit
(1) START 10
(2) KRA 3 KRA system
(3) OPC 3 Engine running circuit
(4) PTO 10
(5) ACC 3
(6)
(extra
fuse)
3
(7)
Slow
blow fuse
30
Check circuit against wrong
battery connection
2. Replacing bulbs
Replacement of the headlight bulb
1. Open the hood.
2. Turn bulb socket to remove socket from headlight
housing.
3. Push bulb down and turn 1 quarter turn to remove
bulb from the socket.
4. Install new bulb to the socket.
5. Install the socket in housing.
6. Close the hood.
Headlight LED bulb
12.8 rated voltage/0.1 AMP/
7.96 MSCP
3. Checking and replacing blades
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key.
• Blades may be sharp. When you handle blades,
wear heavy gloves or wrap the end of the
blades with a rag.
NOTE :
• Before checking or replacing the blades, wipe
grass and mud off the top and inside of the
mower.
Especially, clean up inside the belt cover,
because otherwise the belt life will be reduced.
Checking
The blade cutting edges should be kept sharp at all
times.
EVERY 1 YEAR PERIODIC SERVICE
T2090BR-AU,T2290KW-AU,T2290KWT-AU
To Next Page
Loading...
Need help?
General
