NOTE :
• Cruise control device will not operate in
reverse.
IMPORTANT :
• To prevent the damage of cruise control device,
do not depress the reverse pedal when the
cruise control device is engaged.
(1) Speed control pedal (A) “FORWARD”
(B) “REARWARD”
STOPPING THE MACHINE
1. Release the speed control pedal and depress the
brake pedal to stop the machine.
2. Push the PTO switch to the “DISENGAGED”
position.
3. Slow the engine down.
CHECK DURING DRIVING
IMPORTANT :
Immediately stop the engine if:
• The engine suddenly slows down or
accelerates.
• Unusual noises suddenly occur.
• Exhaust fumes suddenly become discolored.
While driving, make the following checks to see that all
the parts are functioning normally:
1. Hour meter
The hour meter indicates in 5 digits the hours the
machine has been used; the last digit indicates 1/10 of
an hour.
NOTE :
• As the hour meter works electrically, it starts to
work when the key switch is turned to “ON”,
regardless of the engine running or not.
(1) Hour meter
PARKING THE MACHINE
WARNING
To avoid serious injury or death:
Before leaving the operator's position:
• Apply the parking brake.
• Lower all implements to the ground.
• Shut off the engine.
• Remove the key.
When parking, be sure to set the parking brake.
To apply the parking brake:
1. Depress the brake pedal firmly.
2. Pull the parking brake lock knob.
3. Release the brake pedal while holding the parking
brake lock knob.
4. Before getting off the machine, disengage the PTO,
lower all implements to the ground, set the parking
brake, stop the engine and remove the key.
5. If it is necessary to park on an incline, be sure to
chock the wheels on the downhill side to prevent
accidental rolling of the machine.
(1) Chock
OPERATING THE MACHINE STOPPING THE MACHINE
T2090BR-AU,T2290KW-AU,T2290KWT-AU
To Next Page
Loading...
Need help?
General
