Simplified Maintenance and Repair
114
shall be 2.6L each time (if the engine oil filter is
included, then the replenishing volume shall be
2.7L).
4. Fully tighten the Oil Level Guide.
5. After warming up the engine, stop engine and wait
for 1 minute; then verify oil level with Oil Level
Guide.
1. Drain Bolt
It is recommended to use KYMCO original 4-stroke
engine oil.
The following conditions may expedite oil deterioration.
An early oil change is advised.
Riding on pebbled roads often.
Riding short distances often.
Idling often.
Riding in the cold area.
When replenishing oil, make sure the oil level is not
exceeding the upper limit mark.
Do not mix-use oils of different brand, class or low
quality ones; they may cause engine faults.
Change oil while the engine is still hot; be careful not
to burn your skin.
Oil Filter Element Tightening Torque:
11 N-m (110 kgf-cm)
Engine oil discharge bolt tightening torque:
9 N-m (90 kgf-cm)
Magnet Screw Tightening Torque:
28 N-m (280 kgf-cm)
To Next Page
Loading...
Need help?
General
